Valve DN125 for R717
Dimensions:
A: Outside diameter at pipe insertion end
B: Inside diameter at pipe insertion end
C: Pipe stop diameter, stepped
D: Largest diameter at sealing surface, connection diameter to compressor, pressure vessel etc.
A | Outside diameter at pipe insertion end | 139,7 mm |
B | Inside diameter at pipe insertion end | 130 mm |
C | Pipe stop diameter, stepped | ─ |
D | Connection diameter | 240 mm |
Diameter of suitable steel welding pipes | 139,7 mm (DN125) | |
PS35|DN125| GGxx|XX|xx| 8D195 | ||
Spare parts | Completion kit without flange | 361 339 46 |
Single flange | ||
An information sheet is available for mounting the valve. Depending on the mounting direction, a certain ground clearance is necessary, especially for the 2 screws below the valve spindle.
Connections with the same dimensions are not necessarily interchangeable!
There are often bushes, flanges, pipe connections or valves with similar dimensions, but they cannot necessarily be used with the same products (compressors, pressure vessels etc.)! Which connections are available for which product is listed in the corresponding tables.
If a valve is ordered as a completion kit, it is installed between the compressor and the bush / flange.
In contrast to the initial order, the spare parts do not differentiate between R717 and other refrigerants: Only valves that are also suitable for R717 are supplied, therefore the part numbers are repeated.
Observe tightening torques for screwed connections according to maintenance instructions AW-100!